Posted by Allan In NE on June 16, 2008 at 15:45:17 from (148.78.243.26):
Posted this over on the Farmall board, but maybe I'll get a bit more traction with it here too.
Need some ideas:
Got a problem; not great, but it is just driving me crazy 'cause it just isn't "right". A little slop between the pitman arm and it's gearbox shaft. Would probably outlast me the way it is, but it just bothers me.
The shaft is roughly 1 1/8" in diameter, splined and TAPERED. Splines are not quite as big as a 540 PTO shaft and roughly 1 1/4" to 1 1/2" long.
Anyhoo, over the years, this thing has been allowed to get loose and wobble the cinch fit out a bit. Not "real" bad, but enough that I just don't wanna trust it.
I can't just "washer it up" on the taper, because then the pitman arm would be too close to the gearbox and would hit the cover bolts.
How in the heck can I tighten that taper-fit up? Maybe "shim" it with a wrap of tin foil in and around the shaft splines?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
