They'll ask for it even if the trees are technically on town/state deeded roadway -- if you deny it, they could always measure afterwards and decide your permission wasn't needed ;)
If you refuse, IIRC the utility can appeal to the town's Tree Warden. Yes, we have people called Tree Wardens. They're responsible for protecting "shade trees" but also removing dangerous trees from along the roads.
Usually I don't see a big hassle either way. You do see the occassional hack job that makes you cringe and wonder why they didn't just take the whole thing down.
Gave 'em permission a few weeks back for my place -- I have 600' of frontage on two roads. I'm not worried about the roads since there's nothing particularly scenic on either.
They will be trimming on my property, too -- my transformer is on a pole 200' in from the road. Actually real happy to see that -- I have a couple Ash trees with ash yellowing that ain't looking so hot, plus a maple near the lines there. I work from home mostly, so when they're here, I'm going to see how much I can convince them to drop the whole trees. I can cut 'em up for firewood, and it'll give my garden more late afternoon sunlight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
