Posted by Damp;Dservice on April 28, 2008 at 17:54:20 from (12.175.230.39):
In Reply to: custom bailing posted by nickg on April 28, 2008 at 17:45:09:
nickg said: (quoted from post at 17:45:09 04/28/08) I dont usually do any custom work but a neighbor is beggin me to do sum bailin for him. All I have to do is drop bale 300 square bales. What is a fair price to charge. I live in southern indiana.
fuel+twine+maintnance+labor+mileage for you to get there. figure what it will cost to do the job + make a little profit for youself and divide by 300. If you have neighbors like mine that would give you the shirt of their back if you asked them then you already know what to charge, if not, see above formula, With prices the way they are now you sure dont want to get the job done and think to yourself, why did I just have to pay to do that job that I was supposed to make money off of? Just my 2 pennys
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
