Posted by NBAllen on April 17, 2008 at 07:49:11 from (198.246.171.200):
In Reply to: fence question posted by jbfarms on April 17, 2008 at 06:50:46:
It's a question of cost and $$ available. AND $$ in materials and time down-the-road for fence maintenance.
Greater spacing now means less mat'ls & quicker installation, but more maintenance as the cattle work on the fence.
Given the option I'd use nothing smaller than 5" diameter, treated posts. And spaced at ~8' - 10'
BUT...I'd also run a hot wire on the inside of the fence to keep the cattle from reaching through the fence, wallowing down the woven wire, and rubbing on the fence and the posts.
A couple years ago, I removed a woven wire fence for a neighbor - the fence was 10 or 15 years old, but the wire was very straight. The neighbor had an electrified strand of barbed wire 30" off the ground and another strand 10" above the top of the 48" woven wire.
Bottom line - the woven wire is the visual barrier, but the electrified wire keeps the critters in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
