"You got to look real hard at that domestic content ( now called North American content ) as GM has figured Canada and Mexico in their figures."
Ford does the same - especially the Mexican content.
I also notice that "site" freely switches back and fourth between numbers and precentages - and lump all "foreign" cars into one group including those that have no manufacturing plants in the US.
"Few sports cars have captured the nation's imagination like the sleek Ford Mustang, a 21st-century reincarnation of an American classic. The Toyota Sienna minivan, by contrast, speaks to the utilitarian aesthetics of Japan: refined interiors, arm rests and lots and lots of cup holders.
Yet, by a crucial measure, the Sienna is far more American than the Mustang. Statistics from the National Highway Traffic Safety Administration that were publicized in "Auto Industry Update: 2006," a presentation by Farmington Hills, Mich., research company CSM Worldwide, show only 65% of the content of a Ford Mustang comes from the U.S. or Canada. Ford Motor Co. buys the rest of the Mustang's parts abroad. By contrast, the Sienna, sold by Japan's Toyota Motor Corp., is assembled in Indiana with 90% local components."
Sell your Ford and buy a Toyota if you want to keep Americans working.
"Measuring local content is extremely difficult because a part made in America can be assembled from smaller parts, some of which might come from abroad. All of which underscores how the line between what is and isn't American, at least in the auto industry, is "going to be increasingly difficult to pinpoint" as car makers become increasingly international and produce more in local markets, says Michael Robinet, a vice president at CSM Worldwide."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
