Posted by buickanddeere on March 11, 2008 at 06:24:50 from (192.75.48.150):
In Reply to: Re: O/T new well posted by jdemaris on March 11, 2008 at 05:54:01:
The regions around mid to southern Lake Huron, Lake Ontario and Lake Erie are old salt water sea beds. Detroit/Windsor,PortHuron/Sarnia, Goderich & Oil Springs Ontario, Birch Run Michigan. They all rest on top of salt, oil and natural gas. Any deep well will stink of sulphur and be full of iron and dissolved mineral salts. Go too deep and it will be a gas, oil or salt brine. North East Lake Ontario area has natural gas right in the drinking water from deep wells. Sometimes domestic water is stored in a ventilated cistern to allow the natural gas/hydrogen supplied to off gas. Its one of the reasons the Great Lakes are used for drinking water instead of deep wells. Around here the best drinking water is from a shallow open well that"s into an underground aquifer,spring or river above the bedrock. Along the East Coast of Lake Huron in town such as Kincardine. The residents instead of paying outrageous water bill for watering lawns & gardens. They just drive a sandpoint 5-25ft and hit the underground rivers just before they drain into Lake Huron. A 1HP pump, 2" sand point, 15" of pipe/foot valve and has 5ft of water above the foot valve. It will pump for a couple of days non stop without running dry to fill an inground swimming pool.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
