Nancy, grab a bat, hammer or other blunt tool and beat the snot out of one of the tire treds. It will make you feel a lot better without wrecking anything that cost $$ to replace.
I am not sure if a 96 still has the thermal actuator to lock the front axle in 4WD, but if it does, they were a major PITA that often took up to two minutes after you put it in 4WD to lock the axle. The conversion to the motorized actuator makes a totally different truck out of them, which shifts to 4WD in under 5 seconds.
If yours still has the slow thermal actuator, then you need the motorized actuator, and the spacer and wiring harness adapter. I converted mine (92 model)2 years ago and think it is well worth it. I also looked at that manual cable operated conversion, but was afraid that in freezing temps, ice might lock it either in or out of 4WD. Coming from the guy who declared that this 92 Chevy is the worst piece of crap I have ever owned, I must say that front axle actuator conversion is an absolute joy to use compared to the thermal actuator.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
