Posted by jdemaris on February 16, 2008 at 14:26:31 from (67.142.130.15):
In Reply to: Re: O/T ford diesel posted by george md on February 16, 2008 at 11:05:00:
Not all the 94 F350s with 7.3 diesels came with dual-mass flywheels, and many of those that did, got converted back to a standard one-piece.
About the gear ratios - how do you figure the 5 speed is designed for a 5.44 axle ratio? That truck would be revving at 2800 RPM at 65 MPH which is not good for a diesel. It would be awful to drive. Most of the 6.9 diesel Fords with C6 autos came with 3.55s or 4.10s. A 3.55 with a ZF5 will rev 1850 RPM at 65 MPH, and with a 4.10 it will rev around 2100 RPM which is a great setup for an rig used for towing and light use.
My Dodge with the Cummins 5.9 has the Gertrag 5 speed and 3.50 axles and works great - for towing and for highway driving.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
