Posted by rustyj on February 06, 2008 at 20:30:34 from (72.77.19.179):
In Reply to: OT: Mack farm dump truck posted by wantadumptruck on February 04, 2008 at 22:49:18:
When i joined our local fire company, they had a 1960 B60 Mack, tandem axle, 5-speed and 4-speed aux. It hauled 2000 gallons of water for fires, and to fill cisterns, etc. It had the 6 cylinder gasoline engine, and was kind of under powered. The powers that were, in the Fire company, were short sighted when the truck was bought, and they didn't want to get a diesel, as nobody near-by sold diesel fuel! So, when i finally got to learn to drive it, i set out to learn how to get it moving on our hilly roads. It took a while, but i finally got good at driving it, even with my artificial left foot! I could even get it to a fire without using the clutch, except on steep hills, and to stop. Some of the drivers wouldn't take it out on a bet, but i liked driving it. Sort of a challenge. Somebody asked me how i could drive in to the fire company parking lot, in my 1960 Renault Dauphine, a real small car, get out, climb into the Mack, and drive it down the road. I told him i never thought about it, just did it! they finally sold it to a well driller. The last time i saw it, it was in bad shape!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
