Posted by ntmcj on February 04, 2008 at 10:03:14 from (4.88.8.207):
In Reply to: appreciate a listening ear posted by old fashioned farmer on February 03, 2008 at 17:43:48:
Understand your dilemma. My ancestors were once major landowners where I grew up. I was fortunate and inherited a small part of my great-grandfather's homeplace. I live 200 miles away and work a regular job. I would starve if I had to farm it. Most of it is in timber and a cousin keeps a few cows in the pasture. Hopefully, when I retire in about 10 years I will move back and do some hobby farming. In this area, scale farming is all but dead. You are probably going to need to make more than 9.50 an hour in order to get started, even if you get the land free of charge (which it doesn't sound like this would be the case). Many parents of the older generations worked their cans off so their children could get an education and not have the worry of failed crops, bank foreclosures etc.. So don't be terribly hard on your mother. What you do not want is to wake up at 55 or so and have no retirement built up or no form of health insurance. One hospital stay would wipe out what you have worked a lifetime for. I am in the AF Reserves and we have scads of folks around my age (45) coming in after pulling a tour in the early 1980s and getting out. They can see retirement approaching and they either have nothing saved, or the company retirement plan went belly up (ie. Delta Airlines). They will be pulling weekend duty for the next 15 years or until they get 20 good years in so they can get a retirement and health insurance at age 60. All I am saying is make sure you have all bases covered.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
