Posted by trucker40 on January 26, 2008 at 01:26:05 from (69.152.174.178):
In Reply to: Day 2 posted by Lanse on January 25, 2008 at 20:34:48:
I went back and looked at Day One and see you allready have Kerosene in it.After thinking about it the jack might work if you did it like this just put a little pressure,not raise the wheels up enough to come off the floor or if you do come off the floor not much.Another way is jack up right rear wheel if you can get the transmission in a gear then every time you walk by the tractor lean on the back tire both ways.If you leave the kerosene and whatever else in there when you do this it might work.I broke a tractor loose by jacking up the back wheel before but it took a couple of weeks pouring diesel and ATF and WD 40 in it and pushing on the tire every time I walked past it.I was in a hurry because somebody wanted to buy it if it ran.It took a long time to get it running.You just dont want to get real rough with it no matter what you do.Just remember to be patient.The more patient that you are the less you will need to spend on parts,then when you need parts look in lots of places for them.TSC is not the only place that sells tractor parts.You dont need a hammer much.Hide all the big hammers and cheater pipes,that will save you money too.After you try every thing else first,then it may be allright to get a hammer or a small cheater pipe say not longer than 3 foot long.That dead blow hammer would be a good idea.Keep squirtin penetrating oil every day everywhere its got something you think is stuck.After about day five of squirting penetrating oil you might want to start thinking about doing something different if its not working.Sometimes you can break stuff loose with a propane torch.Its better to start with a propane torch and heat it up first.Then spend another week squirting it with pentrating oil before you get the big torch out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
