Posted by Janicholson on January 18, 2008 at 10:23:21 from (199.17.6.122):
In Reply to: Stuck now what.? posted by Walt Davies on January 17, 2008 at 16:22:55:
Here is a non toxic method of getting it out (not running). Collect 2 5/8 link 16' log chains, 150' of 3/4 inch wire rope and snatch block from a rigging company. (this is a pulley and block with a hook on the pulley frame), one 10' length of 10inch I beam. and 4 pieces of 3X12 header material 48" long. Take off the weights in front! Attach the chains to the fron low side of each inside dual where the mud hits the tires.run the chains up and over the tires in the middle of the tread. on the back side of the tires, dig about an hour on each side to allow positioning the header material behind each tire. as a ramp. Place the beam across behind the tractor and attach the pull end of the chains to it so they can pull directly rearward. Attach the snatch block to the middle of the beam, pulling rearward. Attach one end to a modestly sunk in tractor, and the other through the snatch block shiv, then to the tractor used for pulling it out. Keep things pretty much aligned so the chains do not slide off the tires, and it has a 4 to one pull on the tractor while not tipping it over backwards. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
