We narrowered the chisel plow a few weeks back, hadn't had time to hook up yet....Tractor runs good, needs gauges, glow plugs, few wirein' problems, But nothin' major.We centered up on the chisel plow frame, moved in 6in. from each end, cut out a 3ft.peice on each end, welded the end pieces back on. Three springs with plow points on front beam, two on back beam, splittin' the difference between the front three. As You can tell, I don't know much about farmin'....When I was a kid, late 40s early 50s We raise cotton ran a few cows, corn, and a big truck patch.Last 20 years I've been playin' with a Farmall A and a Super A, workin' 4 or more acres in the spring. From what some HANDS tell Me I've built up a hardpan from not plowin' deep enough.If I get everything goin' this spring I'll try maybe 10 acres, Organic as possible. I appreciate The way You HANDS have helped Me out on this Forum....If You need info on Weldin' Machinein',Forgein',heat treatin',Gun buildin'...Maybe I can help. Thanks Wild Bill
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
