Posted by L.C.Gray on January 13, 2008 at 18:48:44 from (208.193.186.135):
In Reply to: Re: OT/chevy engine posted by glennster on January 13, 2008 at 18:20:58:
Huh? 135 degree?
The 348 & 409's (W engine) were still 90 degree motors. The only way I can figure any one mistaking it to be anything other than 90 degree is that the cylinder decks were milled off at at an odd angle. The surface of the heads were basically flat and the large open combustion chamber was formed by the wedge left at the top of the cylinder. The bores and crank throws were still 90 degrees apart.
Check out this months Car Craft and theres a big story in there about building a vintage 409 into a 500hp 481 stroker by boring .060 and triming the main journals on a 454 crankshaft to fit in the old the W block. Kind of a waste really, I'm sure they could have bought an equally potent more reliable 502 crate engine for less simoleans.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
