Posted by RAB on December 09, 2007 at 01:52:55 from (195.93.21.134):
In Reply to: International Magneto posted by fordpower30 on December 08, 2007 at 16:03:28:
I would think that if you find the wire size and then get as much on as you can, in the package size available, you will not be far off, plus or minus a few hundred volts. The primary will be more important, I would have thought. (For the boys who are thinking' how fast is the engine turning?' this might be a revelation). Alternatively get a mag-winder to do it for you; they will know what works and likely won't be giving the information away. You might be able to find the turns ratio from voltage step-up working from the primary turn count and magneto output at a reasonable rotational speed (to ensure a good starting spark potential). Regards, RAB
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
