Posted by Iowa crops and hogs on November 20, 2007 at 03:02:31 from (75.104.160.59):
I am building an addition to my shop--a 20 X 50 lean-to for an office, laundary, and meeting room. Will be very well insulated. 8 foot ceilings. This addition will cost about $7500 without the heating system.
At first I was going with a vented wall unit(propane), but if I go with 3 separate rooms, how do I get enough heat into the 2 rooms without the wall unit? Brainstorming about half-walls instead of totally separate rooms to let the heat circulate, and then adding a little supplemental baseboard heat to the rooms without the heater. Then I wonder if I should just try to find a small used furnace, and duct the heat to each room. I know this would be the best, but probably more costly and complicated. I could settle for only 2 rooms and then I would need only 2 propane wall units. I do not like unvented units.
Could all you guys brainstorm along with me on what to do? Iowa location. Concrete and steel shell up so far. Would like to get heating system in for $1000 Max-hopefully less. Thanks in Advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
