Posted by Dave from MN on October 17, 2007 at 19:24:47 from (67.133.91.236):
OK, while digging holes for post. I decided to go in the feilds and make some holes to drop in RR ties for anchors in case I end up running electric fence to graze the cornstocks and ad a bit of mother natures fertilizer. I am sandier soils. The 1st 3"-6" were soft. Then the next 3"-8" where like freaking cement. I am assuming this is the "hard pan". Below this area the soil was soft and easy to excavate, but in some areas was a poor golden sand. Will this hardpan restrict root growth? I really do not want to moldboard plow it that deep for fear of burying the shallow good topsoil in places and displacing with that undesirable soil. I have access to a subsoiler and a big tractor. Would this break it up with out reducing the good topsoil? I would like to do it this fall ASAP, now that I discovered that hard pan, to (in my mind)allow the rain to "get down there for next year". Feilds have been farmed with big articulates and feild culivators for about 15 years. Need some experienced advice on this NRCS would like to see no till, but... whats best?? I'm clueless on this issue.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
