Posted by doogdoog on August 19, 2007 at 21:10:32 from (76.88.187.67):
In Reply to: Fuel tank has a hole posted by 37 chief on August 19, 2007 at 12:50:18:
Aloha, Fiberglass resin isn"t a good patch anymore if you use any type of ethanol gas. We had a lot of problems with ethanol gas in fiberglass tanks and it produced some gummy stuff that ruined a lot of small boat engines. If the tank has a rusted spot, check out the rest of the tank because you may have more holes starting (in that case, get another tank). You could do as the other poster said (screw in pan head sheet metal screw with gasket) and then cover the patch with a fiberglass cloth, JB weld, LPS Strong steel stick, etc. Just be sure to apply to a clean dry surface.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
