Tractor Talk Discussion Board |
Re: newholland 273 baler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmer boy on July 25, 2007 at 19:48:30 from (216.129.11.67):
In Reply to: newholland 273 baler posted by ric1 on July 25, 2007 at 11:39:01:
We own a 273 baler and it makes good bales and it can go at a fairly quick speed.(4-5mph) and get done 400-500 bales an hour if you want to constantely shift between 4-L and 1-H it also depends which cut your on. In first cut we get about 100 bales/acre and pushing it can get done 2-200 bale loads an hour. We stack all the bales. As far as constienty goes every bale will be fairly close to one another in length and will always be uniform in terms of banana bales.This is all just my experience with this baler and every baler is different. It just has to be adjusted correctly
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|