Tractor Talk Discussion Board |
Re: Well, I can't believe I did this.............
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry NE IL on July 16, 2007 at 13:42:38 from (152.163.100.139):
In Reply to: Re: Well, I can't believe I did this............. posted by Luke S on July 16, 2007 at 10:04:42:
I got the same one only it's green and had a different name. ILOVE IT!! Dragging don't hurt anything, unless you drag too far. If you need to move from one side of a field to another, drop the bales you have before moving or you'll rub through the strrings. I've changed to plaswtic twine for that reason. When you load your wagon, start your two stacks ab out 1.0' apart. as you build the stacks keep edging them closer together so thay lean on each other, finish with bales cross wise the trailer then one stack length wise in the middle. Holds the load tight. Always stack each layer cross wise to the previous one. You can't tie them together like when hand stacking. When stacking in the barn, always place a dozen bales on edge before stacking with the grapple. The first course must b solid to support the rest of the load. Good Luck, you and your back are going to love your decision! Larry NE IL
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|