|
Tractor Talk Discussion Board |
Re: O/T- I AM PLANNING A GROUNDHOG MASSACRE!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Anderson on July 07, 2007 at 17:32:40 from (70.22.104.190):
In Reply to: O/T- I AM PLANNING A GROUNDHOG MASSACRE! posted by dds-inc on July 07, 2007 at 17:15:43:
Try the flare method. First find all of the holes- usually a groundhog digs a marked hole, and an unmarked hole, dug from underneath. Dig these holes out big enough to fit an old milk jug into real tight. When you are sure the hog is in his hole, drop either a highway flare cut in half, or the commercially available rodent "bomb" into the hole, after lighting it. Put your jugs into the holes, and shovel the dirt over the holes, and tamp with your foot. Why the jugs? slows them down long enough for the sulfur to suffocate them. Also, if you find any roadkill and shove that down the holes, that will discourage them from coming back.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|