Tractor Talk Discussion Board |
Re: # of tied bales
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mjbrown on June 25, 2007 at 10:13:40 from (132.236.155.135):
In Reply to: Re: # of tied bales posted by peaster on June 25, 2007 at 09:20:55:
Hold the two wire ends in an X with a 3" extra past the intersection. Now twist an end around and around the other piece (new spool toward the old and vice-verse). Try and do it nice and tight and use a pair of pliers to wrap the very end close to the wire so it won't catch on the wire guides. New Holland makes a little tool that does it nice but I don't recall having much problem with spices going through unless it happens to come up right at the twister. Glad I don't do wire bales any more though.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|