|
Tractor Talk Discussion Board |
Re: Detroit 4-71
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 350 HU Don on June 22, 2007 at 17:58:44 from (68.191.166.16):
In Reply to: Detroit 4-71 posted by Roy Suomi on June 21, 2007 at 20:55:46:
This engine is a good horse. I spent lots of miles in a semi tractor powered with a 6-71, N65 injectors, rated at 238 hp and pulling 73,000 lbs. the 4-71 with N65's would be 148, but those are big horses. The Detroit is a more economical engine than the Cummins and lasts longer. We ran a fleet that included both Detroits and Cummins and the Detroits got about a tenth of a mile per gallon better fuel mileage and lasted, on average, about 100,000 miles further between overhauls than the Cummins. In a single axle straight truck this would be more than enough power. the big question is whether you want to spend all it would take to convert this thing. Look into that carefully.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|