Re: 1030 case idle set

Posted by No tools on May 30, 2007 at 19:34:30 from (71.79.47.23):

In Reply to: 1030 case idle set posted by Dairy Farmer in WI on May 30, 2007 at 18:03:29:

The long threaded rod along beside the engine on the right side of the engine.

Should have a short rod about 12in long attached to the inj pump.

Well on the long rod it needs to be lenghtened.

There is two nuts on the Rearward end of the rod.
Back the back one off and follow up to it with the other.To get the desired length you want to kill her out.Check under the foot throttle heel to make sure its not packed full of dirt and rock.
Had that happen also.Holds her way up on idle.

Now the name on the pump Germany. It was built in Germany.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]