Tractor Talk Discussion Board |
Re: Cleaning with solvent after power wire brushin
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ken Crisman on May 24, 2007 at 08:14:56 from (71.116.61.161):
In Reply to: Cleaning with solvent after power wire brushing posted by Kajun on May 24, 2007 at 07:22:08:
The best prep for painting is to use metal conditioner on your wire brushed & ground areas . Let it sit a spell so it'll work on the embedded rust eyes can't see . Then wipe off with hot water on a rag than blow dry immediately . Its best to wear rubber gloves using it this chemical . I then wipe clean metal off with Prep Sol which takes any oily film off so paint will adhere .I had an autobody shop years ago so I still use what I learned on my tractors . I hope I've helped . God bless, Ken
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|