|
Tractor Talk Discussion Board |
Re: John Deere 790 Bent Pushrod
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Howard H. on May 07, 2007 at 23:37:50 from (65.197.84.160):
In Reply to: John Deere 790 Bent Pushrod posted by Bob Blake on May 07, 2007 at 16:09:50:
Before you get too worried, do a pressure test on each cylinder - dry and then wet, to see if/where you are losing compression... That will give you a better idea of where to start. I'm not sure how pouring some fuel directly into it caused a bent push rod... Especially no just a teaspoon... Unless you had a valve sticking from other causes maybe... Are you sure there are no intake or exhaust restrictions? Or also - I had a rat eat a hole in the intake air hose which caused it to lose all power on the top end, since the turbo could'nt build any pressure. Howard
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
