|
Tractor Talk Discussion Board |
Re: O.T. 15 H.P. Briggs Stratton Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul Janke on April 30, 2007 at 20:29:07 from (216.166.168.53):
In Reply to: O.T. 15 H.P. Briggs Stratton Question posted by genos on April 30, 2007 at 19:42:59:
I have been one to just pull the dipstick on a cold engine to check the oil. I have learned that on some of the small engines the cap which has the dipstick attached to it is airtight so you can get a false reading of oil level because of airlock. On those engines you need to remove and wipe off the dipstick and put it back in to make sure of proper measurement. This could be causing you to think the oil level is correct when it may not be.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|