|
Tractor Talk Discussion Board |
Re: 4630 Ford Power Steering
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wisconsin Bill on April 22, 2007 at 15:25:09 from (216.127.196.129):
In Reply to: 4630 Ford Power Steering posted by detel on April 22, 2007 at 14:35:20:
Water will not build pressure enough like the proper oil, but it should purge out most milky stuff as you feed in new oil. Get only oil to come out of that return line and steering may return. Then find where water is getting in. Usually a gasket gives away- and does it sits outside? I just went through that with my 530CK in the tranny. Some earlier owner used silicon in stead of the 15 dollar gasket and water got into the trans; split it, remove water, put in new oil and good to go.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|