|
Tractor Talk Discussion Board |
PHOTO - the opening furrows
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in Wales on April 20, 2007 at 23:41:15 from (86.142.187.162):
HI Gang;
This shows the opening furrows. So this guy has gone up the plot turning a very shallow single furrow using only the rear mouldboard. Then back down the otherside again a very shallow single furrow. This leaves the open furrow, the split.
The next run he uses both mouldboard to plough back those shallow furrows towards the centre split at normal depth. This turns back those first
2 furrows and sandwiches the grass underneath. So all the grass roots have been cut off and stops any grass growing. These opening 2 furrows are slightly higher than the rest of the furrows. We call this the "cop" and the last open furrows the "rean". Dont know where these names originated. Another term used here to travel accross the field and then back down on the next row is a "bout". Hope you can understand my descriptions from the photos. Cheers David
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
