|
Tractor Talk Discussion Board |
Re: Ford 841 work with a case 6000 3 bottom Plow?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 30 pointer on April 17, 2007 at 07:26:00 from (69.128.25.70):
In Reply to: Re: Ford 841 work with a case 6000 3 bottom Plow? posted by JWCinMS on April 11, 2007 at 15:57:14:
THe Furrow wheel is actually a normal tire which is mounted on the side of plow. Can I remove the front plow? I have sometimes a problem with clearance when the lift arms are all the way up. The plow has a tendency to scrap on the ground. I wanted to use the back two buttoms. Do you see a problem with that?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Diesel Vs. Gasoline - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I am in the market for an older tractor (to be read... cheap). I have been told a diesel holds up better than a gasoline engine as far a wear, tear, neglect and abuse. Since I am looking at older tractors that have probably been through it all, is it better to buy diesel? I do expect to have to do a good bit of work on
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
