Re: Ford 841 work with a case 6000 3 bottom Plow?

Posted by JWCinMS on April 11, 2007 at 15:57:14 from (199.133.90.83):

In Reply to: Re: Ford 841 work with a case 6000 3 bottom Plow? posted by 30 pointer on April 11, 2007 at 07:43:10:

I just got back to the forum and the question was answered in a later post. If you take the back bottom off you will need to move the longer landslide or furrow wheel on the back of the rear bottom up to the second plow. Most plows have a long bar or beveled wheel on the rear bottom. Most of the modern Ford plows (mid 50s and later) had the wheel which helped cut down on the drag by a small amount. You will likely need to remove the vertical portion of the frame for the last bottom if you are going to plow very deep because it will be traveling over the ground that has not been plowed yet.

Replies:

• Re: Ford 841 work with a case 6000 3 bottom Plow? 30 pointer 07:26:00 04/17/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]