|
Tractor Talk Discussion Board |
Re: off/road #2 diesel vs #2 auto diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john in la on June 03, 2007 at 20:23:10 from (66.157.50.151):
In Reply to: off/road #2 diesel vs #2 auto diesel posted by ric1 on June 03, 2007 at 16:21:25:
The exact difference will depend on who your supplier is. #2 High sulphur diesel has up to 5000 ppm of sulphur. It can only be used as off road and will always have a red dye added. #2 Low sulphur diesel has up to 500 ppm of sulphur. It can be used on road in all 2006 and older vehicles. It can also have a red dye added and be sold as off road no tax fuel. #2 Ultra Low sulphur diesel has up to 15 ppm of sulphur. It can be used on road in all vehicles including 2007 and up. It can also have a red dye added and be sold as off road no tax fuel. Since all stations want to be able to sell to all buyers including owners of 2007 trucks they stock Ultra low sulphur at most stations. Since bulk tanks are very expensive to buy and maintain most suppliers just add dye to the Ultra low they already have in stock. If you buy from a large supplier that sells a lot of off road fuel they can justify the extra tank cost so may have lower grades of off road diesel available. You can also get lower grades of off road diesel if you have your supplier load it at the loading rack and deliver a transport load direct to you. The minimum delivery charge for diesel from a transport truck is based on 7000 gals. The differance between #2 off road diesel and #2 heating oil is the code the computer charges for the load. It is loaded out of the same tank using the same hose. The computer only charges it differant. The differance in most heating oil that consumers buy is due to the fact that the supplier adds #1 diesel or kero into the #2 to keep it from jelling in the tank.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|