Tractor Talk Discussion Board |
Re: 6' or 7' cutter bar for JD # 5 mower?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike Van on April 06, 2007 at 17:33:12 from (24.151.104.209):
In Reply to: 6' or 7' cutter bar for JD # 5 mower? posted by John in CT on April 06, 2007 at 15:57:56:
Get the 7', every 6 times around the field, you've cut one complete trip around out. The guys are right, sharp knives adjusted right, and clean shiney guards. When I used to finish 1st cut, i'd "paint" on a light coat of oil on the mower, guards especially. Next time it was used, mow 10' in some weeds, it was clean, no rust. End of the year, same thing.
Replies:
Home
| Forums
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|