Tractor Talk Discussion Board |
Re: OT: Value of pre 64 Winchester?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mjbrown on April 03, 2007 at 16:24:15 from (64.179.7.204):
In Reply to: OT: Value of pre 64 Winchester? posted by Tx Jim on April 03, 2007 at 13:23:20:
Value will depend on condition, originality and rarity. There are many '94's out there. If yours has original factory finish in excellent condition with rare features that are original Winchester factory installed such as, engraving, unusual caliber, extra long or short barrel, octagonal (if round was standard) or half round barrel, unusual length tubular magazine (full length mag under a half round barrel is unusual) and so on will fetch more than a run of the mill '94 that has seen a lot of decades of woods time. Check the Cody museum. All the old Winchester records are there and you can check on numbers produced with what features. Collecting old Winchesters is interesting, you might consider keeping them.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|