Re: Anyone familiar with NH 717 chopper?

Posted by dboll on April 03, 2007 at 11:02:13 from (65.200.157.177):

In Reply to: Anyone familiar with NH 717 chopper? posted by BLinWMi on April 02, 2007 at 21:30:33:

we ran one for years behind a 970 Case or 1850 Oliver and it stood up fine to 100hp. We always kept the knives and shear bar up which is the key to doing a good job and reducing stress on the drive. Dad would get the drum rolling and run the shear bar in until it started ticking then back it off a little it cut really fine. pans are prone to wearing through. We relined ours once.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]