Tractor Talk Discussion Board |
Re: Flywheel is off .
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DRL on March 31, 2007 at 22:16:44 from (24.32.126.209):
In Reply to: Flywheel is off . posted by two cylinders saves gas on March 31, 2007 at 16:16:39:
The gasket is inside the metal spacer that spins. It is usually a thick cork gasket that will probably be very hard and brittle. You will have to pry it out of there and it will probably break up into pieces. The replacements that I've gotten from John Deere are a rubberized cork. Grease up the new gasket and the crankshaft real good. Be real careful when installing that it doesn't get caught on the splines and gets torn. Hopefully you made a witness mark where the slot in the spacer was in relation to the cover. This will aid in replacing the flywheel in the correct position.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|