Re: John deere flywheel help

Posted by John T on March 31, 2007 at 10:51:08 from (66.244.90.5):

In Reply to: John deere flywheel help posted by two cylinders saves gas on March 31, 2007 at 09:25:06:

If it uses the cork seal inside that D shaped housing under/behind the flywheel, I soak the new one in hot oil prior to installation. DONT FORGET the tip/pin on the inner flywheel near the center fits back in the open slot in the oil slinger (also in the D housing) so it turns it. If the old flywheel bolts are stretched Id use new grade 8 bolts and drive the flywheel almost alllll the way back in (otherwise you end up with excess end play), the spec is somethign like to within 0.015 or so. Torque the 2 big bolts n use her a while n retorque. As the gents told ya GET IT BACK ON THE SAME SPLINE IN TIME.

John T

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]