Tractor Talk Discussion Board |
Re: O/T How many hours a day have you been workin
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RMinVA. on March 27, 2007 at 16:50:43 from (209.145.81.4):
In Reply to: O/T How many hours a day have you been working? posted by Turke Bros. Farms on March 27, 2007 at 13:32:03:
Worked a 12 hr. shift last night. 7PM-7AM. Came home and checked the cows. Found a new calf!! Laid down from 8:30 am to 11 am. Checked cows. Started spreading nitrogen after that. Fed cows after spreading N at 3:30 pm. Found two more new calves!!!! Pulled hay spinner off and hooked up to the CCM tiller for a garden spot,then took it off and put the spinner back on by 5 pm. I then proceded to install a new jack on the manure spreader because I tore up the old one a few weeks back$%$%. Got that jack on and hope I don't forget to remove this one next time I use the spreader. LOL Checked cows again and helped my son remove some motor mount bolts on an engine were going to pull out tomorrow.And now it's almost 8pm here. Think I'm going to take a long nap now. I think I can sleep two rows at a time now. I'm off from the mill a few days too.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|