Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: Propane tank at auction


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by farmerjohninpa on March 21, 2007 at 21:58:20 from (64.136.27.227):

In Reply to: Propane tank at auction posted by TnT on March 21, 2007 at 18:20:10:

first thing to be sure of is that the auctioneer has the papers of ownership from the person selling the tank. these have to be transfered over to the buyer of the tank at the auction!
without that slip it is illegal to fill the tank,,this is a federal law,,under homeland securety.
secondly if it is a " A.S.M.E. tank" inspection and requalification is every 12 years. normally you will find an "E-" followed by the year it was inspected stamped on the collar or the om plate.
if it is a "D.O.T. tank" no requalification is needed BUT it is in your best interest to have it inspected by a qualified person.
look at the valves and the pressure release vavle---if it does not have a rubber cap on it---it must be replaced with a new one of the same size and pressure and have a rubber cap on it to prevent dust etc. from going down into it and causing it not to operate if ever needed,,other wise the vessel can rupture from pressure build up that a non operating release valve cannot dump, and when this happens 99
out of a 100 times death is one side effect. so be careful.
check that hose if it has just even slight crackes showing on the rubber surface any where,,mainly at the end fittings,will need to be replaced by a new " LP " hose. ( 25 footer is roughly $80.oo }
be careful and cautious,look the tank over good for rust especially on the bottom.


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy