|
Tractor Talk Discussion Board |
Axle Housing/Center Section Assemblies (Gasket)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pete, IL on March 12, 2007 at 10:38:10 from (4.131.3.50):
Ready to join the axle housings to the center section on a 1954 NAA after replacing all the bearings and new lower link pins. Does anyone have what they believe to be a bullet-proof way to seal the two together with new gaskets. i.e. Permatex High Tack, or ???. The other problem I have is with the gaskets. They are off-size on the dia. and bolt hole pattern. In order to have them go on, it will be necessary to cut the gasket at the top. Has anyone ran into this problem before? Any experience and/or suggestions from the field with those familiar with this would be appreciated. I am totally new to tractors. Thanks.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
