Tractor Talk Discussion Board |
Re: 246/247 jd corn planter questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike in KY is correct, Jo on March 07, 2007 at 18:21:59 from (216.201.38.50):
In Reply to: 246/247 jd corn planter questions posted by mike3320 on March 07, 2007 at 15:49:56:
Mike in Ky is correct, Joe in Ne is thinking of the check wire not hill drop. Hill drop could be set foe 2-3 or 4 seeds per hill for 15", 20", 22", 28", 32", 33', or larger spacings. That putting the seeds in hills was like taking the hoe out and planting the corn by hand before the corn jobbers before the planters and the first planters were hand operated to drop the seeds in hills as it was too much work to open and close the seed mechinasim for a seed at each place when it took 2 people to operate a 2 row planter, one to drive the team and the other to do the planting moving a lever side to side and back for each hill of corn.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|