Tractor Talk Discussion Board |
Re: OT: Horse Fencing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 1941 farmall a boy on March 03, 2007 at 00:01:28 from (216.98.171.35):
In Reply to: OT: Horse Fencing posted by John Van Valkenburgh on March 02, 2007 at 20:54:51:
I work for a person that has race horses there is about 10 of them right now. For the fence there is wood post ever 9 feet and about 5 or 6 wires on them the wires go thrue the wood post but the hole thing is ELECTROLYTIC it run"s off a box that is powerd by soler. The wood post is about 5 inches round and 6 to 8 feet tall it works good keep"s them in. You can find all the stuff at like a tsc any thing like that. The wire will not bend out of place you can pull on it and it will go right back in place just make shure you have the power off as i found out it does not hurt the hoeres just make them know its there.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|