|
Tractor Talk Discussion Board |
Re: Cliff Neubauer and Allan in NE - Farmhand 235
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TGIN on March 01, 2007 at 04:10:47 from (4.224.216.123):
In Reply to: Re: Cliff Neubauer and Allan in NE - Farmhand 235 posted by Allan In NE on March 01, 2007 at 02:48:59:
Allan , I`ve got a little 574 with a 2250 QT loader , the mounts just bolt to the holes on the side with no cross member . I`ve had some real loads on it without a problem . I`ve used it to load logs alot and a 16'x30" white oak can put some wait out front , always put a log on the bale carrier on the back to hold it down . I`m talking dry ground and first gear . I have changed front wheel bearings several times but that could be from creek water . I`ve had it sence 1981 and I was a little ruffer on stuff back then than I am now .
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
