|
Tractor Talk Discussion Board |
Re: OT:Chev 1T engine swap Question Y-Block Truck
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by benny2 on February 22, 2007 at 16:37:55 from (66.45.222.23):
In Reply to: Re: OT:Chev 1T engine swap Question Y-Block Truck posted by Allan In NE on February 22, 2007 at 16:18:32:
Well I have never seen a 400 SBC that didnt crack between the cylinders.
I have a complete 427 setup in a series 65 76 chev truck.
How about going with the 5 speed trans? That is in the s65 truck? Any big advantage of the 5spd? How mush weight will be added with a change like this. How much loss in gas millage?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
