Tractor Talk Discussion Board |
Re: 1466 Int/Farm No oil pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by fixerupper on February 16, 2007 at 06:55:23 from (206.72.37.202):
In Reply to: 1466 Int/Farm No oil pressure posted by Walt7777777 on February 16, 2007 at 05:29:48:
Walt, after you get the problem solved, it wouldn't hurt to do like WJ said and rig up a manual gauge permanently. I did this with the 1086 years ago after the circuit board behind the elect gauge went bad, making the gauge suddenly read zero and scaring the bejeepers out of me. In the oil galley there is a port on the right rear side of the engine that you can tap in to. I think it's a 1/8 inch NPT hole. I just rigged the gauge so it is in front of the cab window by my right foot. Jim
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|