|
Tractor Talk Discussion Board |
Re: Allis Chalmer HD6 Dozer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Turke Bros. Farms on January 30, 2007 at 10:50:36 from (205.188.117.14):
In Reply to: Allis Chalmer HD6 Dozer posted by charlie2pop on January 29, 2007 at 18:12:28:
We had one a few years ago. If its the same ours had a Buda Diesel 4D344. The trans on ours used a hand clutch, direct drive to two steering clutch packs that were dry. Eventually with some dirt and moisture in the clutch rust together. And the bad thing is that the teeth on the fiberous steering clutches breaks away. Thus a dozer that will do nothing but go in a circle. Or if both went it will do nothing. I found a set of steering clutches for ours at $3,200.00. And that was cheap compared to other places. So the repair exceeded what she was worth and we parted it out. Please post what you find, the pump you are referrring to on the front of the crank runs the hydraulic system. good LUCK DTURKE
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|