|
Tractor Talk Discussion Board |
Re: 9-N with oil in radiator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on January 22, 2007 at 18:09:34 from (69.178.229.154):
In Reply to: Re: 9-N with oil in radiator posted by Pitch on January 22, 2007 at 16:46:27:
I'ver seen you post about that oil-in-the-water problem before. So, did the crankcase oil go down by 2 quarts, as the cooling system "gained" two quarts of "oil"? I sure am curious as to what's going on. Since this is a "flathead" engine, there is NO oil passage going anywheres near the cylinder head that could easily leak into the cooling system (OHV engines typically have an oil passage up through the block, matching up with a passage in the head, after passing through the head gasket, and then plumbed into the rocker arm shafts.) The closest pressurized oil gets to the water jacket is in the cam bearing area, matching up with the main bearing "webs". If the bottom side of the waterjacket has an unseen crack down into the pressurized oil gallery in the cam bearing area, that would POSSIBLY provide a passage for the oil to get into the water. Several times, there have been posts on here speculating about that, but I have never seen any information proving conclusively this can and DOES happen. It would have to be a TINY crack, allowing pressurized oil to leak one way, but little water to leak into the oiling system, under gravity, while the tractor is shut down for long periods. The other possiblilty is a casting flaw ("porous casting") that provides a passage from the cam bearing (bore) oiling area to the water jacket. I would think you could pull the head, fill the radiator and engine with water 'til the water level in the water jacket is near level with the head gasket surface, and then pressurize the oiling system with shop air through the port at the rear of the block where the brass fitting adapter for the oil gauge and filter screws in. Any leaks from the oiling system to the cooling system should show up as bubbles rising in the coolant, over the leak. Only problem is, could it be REALLY freaky, and only leak when the block is warm??? Please post back, if you figure anything out!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|