Re: Welding Leaf Springs

Posted by Stumpalump on January 12, 2007 at 07:27:15 from (67.177.206.45):

In Reply to: Welding Leaf Springs posted by in-too-deep on January 11, 2007 at 19:20:36:

You can weld them and you can also hammer arch back in them. I knew a guy who hammered a 3" lift on an old flat fender jeep. It will crack again at some point. To do it better you either need a spring shop to cut you leafs for both sides or get a similar set of leafs from a junk yard and replace the same leafs on both sides. Spring pacs are easy to play around with. You can swap around leafs all kind of ways. Measure width and just get close on thickness and length. But do both sides the same. The longer leafs are for the first few inches of travel and the shorter ones are for heavy loads and big bumps if you want to customize a little.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]