|
Tractor Talk Discussion Board |
Re: Allan did you use the gas wrench yet?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on December 29, 2006 at 00:19:46 from (75.7.243.64):
In Reply to: Re: Allan did you use the gas wrench yet? posted by Allan In NE on December 28, 2006 at 15:10:47:
Just kinda curious, did yo0u put those eyes on there for clamp on's or did they come on that tractor? Kinda redundant to have those eyes for clamp ons when it had hub mounts on it... I had to remove the hubs on my 1600 so I could move them in to narrow it up. I had no choice but to put the rose bud to it and heat them up. I only lost 1 to mucked up threads, the others finally gave in and came out. The nuts weren't tight, the u bolts were just rusted inside the hubs after 40+ years.
Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
