|
Tractor Talk Discussion Board |
Re: LE-Oils, No Tools
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on December 21, 2006 at 11:34:09 from (142.177.87.233):
In Reply to: LE-Oils, No Tools posted by Jim Johnson on December 20, 2006 at 19:43:44:
I can't say that I have any experience with LE products. That said, the sales pitch sounds the same to me as did the LubriLab sales pitch, and I do have experience with their grease, and a couple other products they sell. They've got a whole line of additives for every imaginable oil, penetrants, rust protectants, etc. From my experience, the products are good. They're just not good enough to draw the price they're asking. Last I heard, a tube of grease was around 6 bucks, and a very close equivelant from a major line supplier was less than 2 bucks. I can't honestly say I noticed any difference in the wear rates or failure rates of bearings, bushings, or anything else. Had breakdowns before I used it, while I used it, and after I quit using it. The only difference is that it doesn't cost so much to grease a machine now that I buy it for 2 bucks a tube.... That's not to say there aren't some very poor products out there from the big guys. There are. The LubriLab stuff, and probably the LE stuff would be far superiour to the bottom end stuff from the big guys.... but look around, because the big guys do make higher end stuff too, at a fraction of the cost..... These salesmen generally prey on peoples superstition, and general lack of knowledge about lubricants, and convince many people to buy the stuff based on all these supposed lower repair costs. In 90 percent of the situatuions, nobody keeps track of maintenance close enough to actually corelate any actual savings or expenses to the lubricants they're using. I have no doubt that there are some clients who do have some benefits from these products, but I doubt that the majority ever will. That's my take on these types of suppliers... take it for what it cost... Rod
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|